Pride Mobility Basic Go-Go Scooter Repair and Troubleshooting

Here are a few tips below that may save you time and money to try before calling AP Scooter Repair at 904.5514926.

​

The Pride Mobility Go-Go scooter is the most popular mobility scooter on the market. Understanding your product will save you time and money when an issue arises. All Go-Go scooters have a troubleshooting diagnostic beep, that allows you to figure out what to look for in order to fix your scooter.

 

The beep codes range from 2-9 beeps. Most errors are user error. With this information this will save you a service fee by your local provider. This may also eliminate possible bogus repair charges by a not so honest scooter repair company.

 

When diagnosing your scooter, it is very important to made sure your scooter is fully charged, and you have unplugged the charger. Now what you want to do is turn the get on and listen for the beep. Count how many beeps you hear.

 

If you missed the count, don’t worry, it will repeat until you turn the mobility scooter off. Now that you have determined how many beeps your scooter has made; you can read below. This information will tell you the possible cause of the malfunction.

​

Beep Codes

​

2 – Beeps
Condition: The battery voltage is to low and cannot power up the scooter.
Solution: Replace charge the scooter completely or replace the batteries. Contact AP Scooter Repair at 302.516.7186 (Hours M-F 9AM -5PM, EST)

3 – Beeps
Condition: The battery voltage is too high, and the scooter cannot operate.
Solution: Contact AP Scooter Repair at 302.516.7186 (Hours M-F 9AM -5PM, EST) for further assessment or your batteries and charger.

​

4 – Beeps
Condition: The controller or brain has malfunctioned.
Solution: Contact AP Scooter Repair at 302.516.7186 (Hours M-F 9AM -5PM, EST) as your scooter must be repaired.

​

5 – Beeps
Condition: The electronic brake has tripped, or it was left open.
Solution: Ensure your scooter is in drive and not neutral.

​

6 – Beeps
Condition: The throttle lever was pressed while turning on the scooter.
Solution: Turn the key off. Remove your hands from the tiller. Turn the scooter on.

​

7 – Beeps
Condition: The throttle or potentiometer or the speed pod has malfunctioned.
Solution: Contact AP Scooter Repair at 302.516.7186 (Hours M-F 9AM -5PM, EST)

​

8 – Beeps
Condition: The Go Go scooter’s motor has been disconnected.
Solution: Contact AP Scooter Repair at 302.516.7186 (Hours M-F 9AM -5PM, EST) for further assessment of your mobility scooter.

​

9 – Beeps
Condition: Possible controller trip. The scooters battery pack may have been put in place while the key was inserted.

Solution: Turn off the scooter. Insert the battery pack. Turn on the scooter.

If your scooter does not have any lights at all, this indicates there is no power getting to the mobility scooter. Check to make sure the circuit breaker is not popped on the battery pack. Contact AP Scooter Repair at 302.516.7186 (Hours M-F 9AM -5PM, EST).

​

REMINDER: If your equipment is still not working please call Contact AP Scooter Repair at 302.516.7186 (Hours M-F 9AM -5PM, EST)